XL1 LED 3 wire motorcycle bullet lights with a smooth show chrome finish, offered with amber or red lenses.
Adjures smooth chrome XL1 motorcycle bullet lights are the newest school bullets on the market today. There are no straight lines on this bullet, even the bezel has a radius. These match our smooth chrome Sunset Blvd. and Rodeo Dr. headlight buckets. They have an L.E.D. 3 wire light source and work great for marker/run/turn/brake applications. If you only need a 2 wire light just use the ground (Black) and the high beam (White) and cut off or tape up the low beam wire (Brown). Our flush mount bullets are by far the best seller so we have made all of our XL1 bullets with a flush mount. All of the red lens have red leds and the amber has amber leds, so if you want to use clear lenses it is no problem, just let us know when you order. All flush mount bullets lights come with a 1 1/2" center drilled stainless steel 5/16-24 hex mounting bolt (the wire goes through), nylon washer (to protect paint/chrome), and a 1/2" chrome stand-off. All you need is a 5/16" hole to mount it. The way we hold the bezel on is another important feature. We call this our "Reverse Set screw" or RSS design (see explanation below).

Harley Dressers: We do have a diamond mount kit available for the flush mount Beacons and XL1 bullet lights. The diamond mounts work on Harley Dresser rear turn signal bars. Please see our bullet light mount category.

Victory Owners: Your electrical system will only allow the use of 10 watt if you use the halogen bullets so you must tell us when you order. There is no problem using the leds.

RSS Design: The way we hold the bezel to the housing is called our RSS design which stands for Reverse Set Screw. There are 4 threaded holes 90 degrees apart on the housing. According to the way you mount the bullets, you put the set screw in the bottom hole with a drop of blue thread locker (included) and screw it in until it is flush with the housing. You then push the bezel over the o-ring until it is flush with the housing so that the hole in the bezel lines up directly over the set screw. You then turn the set screw counter clockwise (loosen) until it is tight against the bezel. No more lost bezels!

Measurements: Please click on our bucket measurements category. This will show you the measurements of all of our buckets.