Beacon 1 flush mount raised flames 35 watt halogen red lens motorcycle bullet light
Beacon 1 flush mount raised flames 35 watt halogen red lens motorcycle bullet light
Item# NS13518-R

Product Information

This is our raised flame chrome Beacon 1 flush mount 35 watt red lens halogen motorcycle bullet light. These are used mostly as marker, running, turn or brake lights. These are extremely bright and will give you the extra amount of lighting you need on the rear. Our Beacon 1 halogen motorcycle bullet lights are all made from die cast aluminum, polished to a fine finish and then given our 6 step double copper show chrome plate. They are about 1 1/4" around and are smaller than our Beacon 2 bullets. We use a 20 watt for amber lens, 35 watt for red lens and 50 watt for our clear lens. (You can request any wattage to be installed. They are offered in 3 different mounting styles so make sure what you need before ordering. All of our beacon motorcycle bullet lights are sold in pairs only. With our different mounting brackets they will fit Harley Davidson, Victory, Triumph, Yamaha, Honda, Kawasaki, Suzuki and just about any and all motorcycles. If you are not sure exactly what you need give us a call. Our friendly staff is waiting for your call. By the way we have the best customer service in the motorcycle market. Also see our motorcycle led bullet lights. The leds all come with 3 wires ground, hi & low beam.

Harley Dressers: We do have a diamond mount kit available for the flush mount Beacons and XL1 bullet lights. Please see our bullet light mount category.

Halogen: Halogen motorcycle bullet lights are all single filament so when you use them as turn signals on the front you will loose your running light capability unless you buy a Bad Lands intensifier shown on our electrical page.

Victory Owners: Your electrical system will only allow the use of 10 watt if you use the halogen bullets so you must tell us when you order. There is no problem using the leds.

RSS Design: The way we hold the bezel to the housing is called our RSS design which stands for Reverse Set Screw. There are 4 threaded holes 90 degrees apart on the housing of all of our motorcycle bullet lights. According to the way you mount the bullets, you put the set screw in the bottom hole with a drop of blue thread locker (included) and screw it in until it is flush with the housing. You then push the bezel over the o-ring until it is flush with the housing so that the hole in the bezel lines up directly over the set screw. You then turn the set screw counter clockwise (loosen) until it is tight against the bezel. No more lost bezels!

Measurements: Please click on our bucket measurements category. This will show you the measurements of all of our buckets.